Re: 7905 pass to SIP
https://supportforums.cisco.com/thread/293270;jsessionid=0D1962660DB41BC58ECCDAF07B76C3D4.node0?tstart=0&viewcondensed
To convert an IP phone from Skinny (SCCP) protocol to Session Initiation Protocol (SIP) with Cisco CallManager running 5.0.x, perform this procedure:
On the Cisco CallManager Admin page, go to Bulk Administration > Phones > Migrate Phones > SCCP to SIP.
On this screen, enter a query in order to select the device(s) to upgrade.
On the next screen, select a Phone Profile. Add one if one is not already present.
To add a Phone Profile, perform these steps:
Go to Bulk Administration > Phones > Phone Templates.
When the migrate job is submitted, go to Bulk Administration > Job Scheduler.
Note: Sometimes, the job must be activated. If the job remains in Pending state, activate the Bulk Provisioning Service under Serviceability > Service Activation.
Go to System > Enterprise Parameters and change the Auto Registration Phone Protocol option to SIP.
Restart the Cisco CallManager service.
After submitting a job for migrating phones from SCCP to SIP, make sure that you reset these
phones. Reset phones using Bulk Administration > Phones > Reset/Restart Phones > Query.
For setting X-lite in CallManager 6xxx no different with Setting in CallManager 5xxx
I Give examples :
X-lite extension : 78888
Select Menu : User Management ->End User->Add New :
User ID: 78888
Password: 78888 (you can anythings)
Confirm Password: 78888 (you can anythings)
PIN: 78888 (you can anythings)
Confirm PIN: 78888 (you can anythings)
Last Name: 78888
And You Save.
Next Your Select Menu : Device -> Phone -> Add New
Select Product type : Third-party SIP Device (Basic) -> Next
MAC Address* : (your MAC PC/laptop)
Decription: SEP(your MAC PC/laptop)
Device Pool*efault
Phone Buttom Template*:Third-party SIP Device (Basic)
Common Phone Profile : Standard Common Phone Profile(default)
Location : Hub_None (Default)
PROTOCOL SPECIFIC INFORMATION :
Presence Group : Standard Presence Group (Default)
MTP Preferred Originating Codec : 711Ulaw (gray)
Device Security Profile : Third-party SIP Device Basic-Standard SIP non-Secure Profile
SIP Profile : Standard SIP Profile
Digest User : 78888
And you Save
"Click on the Reset Phone Button to have the Changes take Effect" --> Select OK
In left line : "line[1]-Add a New DN"
Directory Number* : 78888
and you Save
And Your Select Againt Menu : User Management -> End User
Click in 78888 and click in "Device Association" -> Directory Number, Begin With 78888 -> Find
and Check SEPSEP(your MAC PC/laptop) and then your click SAVE SELECTED/CHANGES
In X-Lite Setting :
Open Menu : Properties of Account
User Details : 78888
User Name : 78888
Password : 78888
Authorization User Name : 78888
Domain : ip Add CM
Domain Proxy :
Check "Register With Domain and Receive Incoming Calls"
Send Outbound Via :
Check "Domain"
Good Luck
Best Regards
Satria Indonesia
====================
Resetting to factory defaults
Read the next section before doing this!
Step 1 Press the Menu button.
Step 2 Use the Navigation button to select Settings, and then press the Select softkey.
Step 3 Use the Navigation button to select Network Configuration, and then press the Select softkey.
Step 4 Perform either of these procedures:
Procedure A:
* Press **2. The phone displays "Do you want to reset all system settings to default values?"
* Press the Yes softkey.
No comments:
Post a Comment